IAG Trail Shield® Engine Skid Plate For 2024+ Ford Ranger Raptor

Add a layer of heavy-duty protection and upgrade your truck’s factory skid plates with IAG’s Trail Shield® Engine Skid Plate. This skid plate is designed to seamlessly fit the 2024+ Ford Ranger Raptor. IAG’s Trail Shield® options are even thicker and stronger than Ford’s stock steel shields, providing a greater level of protection to your front undercarriage, intercooler, and other vulnerable components. Whether you're out on the trails or just running errands, IAG Trail Shield® delivers dependable front-end protection for your Ranger Raptor.

The IAG Trail Shield® Engine Skid Plate is constructed from a tough but lightweight plate of ¼” 5052 aluminum. It comes with a complete set of heavy-duty steel fasteners that sink below the face of the skid plate for a smooth surface that can easily slide over obstacles without damage to the vehicle, the skid plate or the hardware. The plate is available in your choice of natural, raw aluminum or a durable black powder-coated finish to protect against corrosion, minor scratches, and premature wear. The raw aluminum finish is left unfinished by design, so bend lines, tooling marks, and light surface scratches from fabrication are normal and cosmetic.

The IAG Trail Shield® Engine Skid Plate features an innovative design with a removable panel for easy oil changes. Unlike inferior products that require taking off the entire skid plate to access the oil filter, our version saves time and hassle, making maintenance quick and simple.

The IAG Trail Shield® Engine Skid Plate can be used as a stand-alone item or in addition to other IAG Trail Shield® Skid Plates for maximum coverage. IAG’s Trail Shield® components were designed to fit tightly together with smooth transitions from one plate to the next in order to keep your Ranger Raptor from getting hung up on obstacles, providing as much protection as possible to your undercarriage.

The IAG Trail Shield® Engine Skid Plate is easy to install and bolts up to your Ranger Raptor’s existing factory mounting points. There’s no drilling required, but you’ll need a ratchet or impact wrench to do the job. Installation can be done in under 30 minutes.

We're proud to say that our products are manufactured right here in our facility in Westminster, MD. IAG Performance was founded in 2007 as an innovator in vehicle performance and off-road products. We offer a wide variety of problem-solving aftermarket products. Our friendly, USA-based support staff is also here to help with any installation questions you might have.

We're proud to offer a limited Lifetime Warranty on the IAG Trail Shield® Engine Skid Plate. In the unlikely event of a structural failure excluding powder coating, we will provide free repair or replacement for life to the original purchaser.